This is an old revision of the document!
The Yaesu ADMS-12 software is specifically for programming the Yaesu FTM-300DR radio. Also, the transceiver parameters and the setup menu items may be edited and configured.
The radio is shipped with a micro-USB cable. This cable is NOT for programming the radio. It is only for performing firmware updates. The cloning cable is the SCU-20 which must be purchased separately.
An alternative method for programming the radio is with a microSD card. A microSD card is not included with the radio but can be purchased separately.
RepeaterBook recommends a microSD card no larger than 32 GB. The radio is not capable of reading larger cards. The card featured above has been tested in two separate FTM-300DRs and has worked perfectly.
The software can import and export in the following formats:
If the ADMS software that you need for your radio is not yet supported by RepeaterBook, you may be able to export the data from RepeaterBook in this format and then translate it to the format required.
The FTM-300DR supports 999 memory channels.
Search Page | North America | Rest of World |
---|---|---|
Favorite | Operational | Development Planned |
Feature | Operational | Development Planned |
Keyword | Operational | Development Planned |
Location | Operational | Development Planned |
Multi-County | Development Planned | |
Multi-State | Development Planned | |
Proximity | Operational | Operational |
Proximity 2.0 | Operational | Operational |
Quick | Operational | Operational |
Travel | Operational |
There are no header field names in the file. RepeaterBook defaults are BOLD.
Field Name | Field Value |
---|---|
Channel No | Sequential beginning with 1 |
Receive Frequency | |
Offset Frequency | Shift in MHz |
Offset Direction | -RPT, +RPT, -/+, OFF |
Operating Mode | AM, FM |
DIG/ANALOG | FM, AMS, DN |
Name | |
Tone Mode | OFF, TONE, TONE SQL, DCS, REV TONE, PR FREQ, PAGER |
CTCSS Frequency | Repeater uplink tone or 88.5 |
DCS Code | Repeater uplink DCS Code or 023 |
User CTCSS | 1600 Hz |
RX DG-ID | Downlink DG-ID or RX 00 |
TX DG-ID | Uplink DG-ID or TX 00 |
TX Power | HIGH, MID, LOW |
M-GRP | OFF |
SCAN | YES, NO |
Step | 5.0KHz |
Narrow | OFF |
Clock Shift | OFF |
Comment |
The RepeaterBook export automatically filters unsupported frequencies and digital modes.