This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
repeaterbookconnect [2021/04/12 16:41] m1hog [Supported Radios] |
repeaterbookconnect [2021/04/12 16:49] m1hog [Kenwood TM D-710] |
||
---|---|---|---|
Line 20: | Line 20: | ||
Band B must be in the correct Band mode to accept the chosen frequency. If it is not, the command will be ignored. For example, if you wish to set a repeater with a frequency of 146.730 MHz, the B Band must be in the 144 MHz mode. | Band B must be in the correct Band mode to accept the chosen frequency. If it is not, the command will be ignored. For example, if you wish to set a repeater with a frequency of 146.730 MHz, the B Band must be in the 144 MHz mode. | ||
- | To select a band, press the F key followed by the pushing down on the right **[BAND SEL] (VOL)** control knob. Repeater | + | To select a band, press the F key followed by the pushing down on the right **[BAND SEL] (VOL)** control knob. Repeat |
**Limitations** | **Limitations** | ||
RepeaterBookConnect cannot change the frequency band. If you want to transfer a 70-cm repeater, the radio must be configured to the proper band before accepting the transfer. | RepeaterBookConnect cannot change the frequency band. If you want to transfer a 70-cm repeater, the radio must be configured to the proper band before accepting the transfer. | ||
+ | ==== Kenwood TH-F7/F6A ==== | ||
+ | |||
+ | To use the RepeaterBookConnect on the TH-F7/F6A. | ||
+ | |||
+ | RepeaterBookConnect will put the TH-F7/F6A into single-band, | ||
+ | |||
+ | On the F7/F6A | ||
+ | Ensure the radio is in PC mode and connected via the standard USB programming cable and OTG adapter to your Android phone. | ||
+ | |||
+ | **Features** | ||
+ | |||
+ | **Limitations** | ||
+ | | ||
==== Kenwood TH-D74 ==== | ==== Kenwood TH-D74 ==== | ||
Line 40: | Line 53: | ||
RepeaterBookConnect cannot add a D-Star repeater to the VFO. | RepeaterBookConnect cannot add a D-Star repeater to the VFO. | ||
- | | + | |