This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
repeaterbookconnect [2021/04/12 16:46] m1hog [Kenwood TH-D74] |
repeaterbookconnect [2021/04/12 16:49] m1hog [Kenwood TM D-710] |
||
---|---|---|---|
Line 20: | Line 20: | ||
Band B must be in the correct Band mode to accept the chosen frequency. If it is not, the command will be ignored. For example, if you wish to set a repeater with a frequency of 146.730 MHz, the B Band must be in the 144 MHz mode. | Band B must be in the correct Band mode to accept the chosen frequency. If it is not, the command will be ignored. For example, if you wish to set a repeater with a frequency of 146.730 MHz, the B Band must be in the 144 MHz mode. | ||
- | To select a band, press the F key followed by the pushing down on the right **[BAND SEL] (VOL)** control knob. Repeater | + | To select a band, press the F key followed by the pushing down on the right **[BAND SEL] (VOL)** control knob. Repeat |
**Limitations** | **Limitations** |