This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
yaesu_vx_7 [2020/12/06 15:54] kd6kpc [Procedure] |
yaesu_vx_7 [2021/02/27 14:11] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Yaesu VX-7R ====== | ====== Yaesu VX-7R ====== | ||
- | The Yaesu [[https:// | + | The Yaesu [[https:// |
The VX-7R has a capacity for up to 900 memory channels. | The VX-7R has a capacity for up to 900 memory channels. | ||
Line 19: | Line 19: | ||
==== Procedure ==== | ==== Procedure ==== | ||
- | - Ordered List ItemAttach | + | - Power the radio down. |
+ | - Attach | ||
+ | - Plug the USB end into your radio and verify the COM Port in the application settings. | ||
+ | - To place the radio into cloning mode, press and hold the [MON-F] key while turning the radio on (" | ||
+ | - Press the [V/M] key (" | ||
+ | - Begin the export from the application. | ||
+ | |||
+ | ==== Troubleshooting ==== | ||
+ | |||
+ | If pressing the [V/M] key does not place the radio into "CLONE WAIT", then this is likely because the keypad is locked. Power the radio down, then power it back up. Press and hold the TX PO LK button until the lock symbol on the screen turns off. | ||
+ | |||
+ | When exporting to CHIRP, you may notice there may be fewer memory channels exported than what was found in the search. This is because CHIRP does not currently support the programming of any DMR radios. Therefore, DMR repeaters are filtered from the export. Other exports like TravelPlus do not perform this filtering and you may need to manually weed your memory channels to avoid attempting to send analog FM transmissions to a digital repeater. | ||